|
The Shot Pot™ with Timer 2 Hot Melt Dual is a bench mounted industrial hot melt extrusion system. It precisely applies two dots of hot melt adhesive at low pressure. It operates easily with a wide range of low to medium viscosity hot melt adhesives.
Actuation of the foot switch triggers solenoids in the unit that initates a timing sequence, which cycles a fluid valve or module. Pressurized adhesive from the melt tank quickly flows through this valve into a nozzle tip and onto your substrate. The cycle time is adjustable to insure exact pattern repeatability or this feature can be deactivated so adhesive cycles only when the foot switch is depressed.
- Complete "Turn-key" bench top hot melt extrusion systems
on one adjustable base plate.
- Foot switch with Y cable to units to actuate adhesive flow.
- Two 3.5 lb. hot melt tank capacity. Teflon lined.
- 3 to 5 lb. per hour melt rate depending on adhesive.
- Removable melt grid in bottom of tank.
- PID precision adjustable temperature controller in Fahrenheit from 100 to 425F.
- Pneumatically adjustable adhesive flow control.
- High Speed valve/module for excellent adhesive shut off.
- Adjustable timer from .1 to 9 seconds for pre-measured adhesive patterns.
- Three nozzles and one extra tank seal included with purchase.
- Optional smaller .25" nozzle included with tanks for small dots.
- Typical adhesive viscosities range between 500 and 5000 cps.
- Typical hot melts used with system are pressure sensitive and
fugitive hot melts.
- Power requirements are 120 VAC, 800 Watts²
- Dimensions are 18" high x 15" wide x 13.5" deep, each.
- Base plate is 16" x 36"
- Weight is 75 lbs. (32.5 lbs per unit + 20 lbs for base plate).
- Shot Pot Adapter Threads are 1/4BSPP.
- Compressed air required: 30-90 psi.
- Six month warranty against defective workmanship
- Method of shipping is UPS.
|
