|
Product
Details:
|
|
|
|
|
|
| 
(Videos
will open in Windows Media
Player)
|
| The
Shot Pot Hot Melt system is
a bench mounted industrial
hot melt extrusion system.
It precisely applies in bead
or dot form a wide range of
low to medium viscosity hot
melt adhesives at low pressure.
Actuation of the foot switch
triggers a solenoid in the
unit that pressurizes the
tank. Pressurized adhesive
quickly flows past the check
valve subassembly attached
to the bottom of the melt
tank and into a nozzle tip.
Release the foot switch and
the system instantly depressurizes
and adhesive flow stops.
Following are specifics of
the Shot Pot:
- Complete
bench top hot system
- Foot
switch with cable to unit
to actuate adhesive flow
- 3.5
lb. hot melt tank capacity,
Teflon lined
- 3
to 5 lb. per hour melt rate
depending on adhesive
- Removable
melt grid in bottom of tank
- Thermostatically
adjustable temperature controller
in centigrade, 50 to 300
C
- Pneumatically
adjustable adhesive flow
control
- Check
Valve subassembly for good
adhesive shut off
- Three
nozzles and one extra tank
seal included with purchase
- Typical
Adhesive viscosities range
between 500 and 5000 cps
- Typical
hot melts used with system
are EVA's, APAO's, Polyamides,
pressure sensitive and fugitive
hot melts
- Power
requirements are 120 VAC,
800 Watts
- Dimensions
are 17" high x 15"
wide x 16" deep
- Weight
is 29 lbs.
- Compressed
air required: 30-90psi
- Six
month warranty against defective
workmanship
- Method
of shipment is UPS
|
|
|
For
more information, please contact:
Glue Machinery Corporation™
4234 Boston St.
Baltimore, Maryland 21224
Toll Free: 1-888-202-2468
Phone: 410-761-2727
Fax: 410-761-5127
Email: info@gluemachinery.com
Visit us online at www.GlueMachinery.com
<---------------------
|
