Product Details:
The Shot Pot™ with Timer Hot Melt system is a bench mounted industrial hot melt extrusion system. It precisely applies hot melt adhesive in dot or bead form at low pressure. It operates easily with a wide range of low to medium viscosity hot melt adhesives.

Actuation of the foot switch triggers a solenoid in the unit that initiates a timing sequence that cycles a fluid valve or module. Pressurized adhesive from the melt tank quickly flows past this valve into a nozzle tip and onto your substrate. The cycle time is adjustable to insure exact pattern repeatability or this feature can be deactivated so adhesive cycles only when the foot switch is depressed.

• Complete "Turn-Key" bench top hot melt extrusion system
• Foot switch with cable to unit to actuate adhesive flow
• 3.5 lb. hot melt tank capacity, Teflon lined
• 3 to 5 lb. per hour melt rate depending on adhesive
• Removable melt grid in bottom of tank
• Thermostatically adjustable temperature controller in centigrade, 50 to 200 C
• Pneumatically adjustable adhesive flow control
• High Speed valve/module for excellent adhesive shut off
• Adjustable timer from .25 to 9 seconds for pre-measured adhesive patterns
• Three nozzles and one extra tank seal included with purchase
• Typical Adhesive viscosities range between 500 and 5000 cps
• Typical hot melts used with system are EVA's, APAO's, Polyamides, pressure sensitive and fugitive hot melts
• Power requirements are 120 VAC, 800 Watts
• Dimensions are 18" high x 15" wide x 13.5" deep
• Weight is 32.5 lbs.
• Compressed air required: 30-90psi
• Six month warranty against defective workmanship
• Method of shipment is UPS

Recent Testimonial:

Hey Pierce, Just finished two jobs with the Shot Pot with Timer for a total of approximately50,000 trays. That's 200,000 glue dots (dime sized dots) and we still have glue left over from the 25 lb box we purchased with the system. We have become so good at this gluing process that we are doing 70 trays or 280 dots in 4 minutes (sustainable for 50- 60 minutes)! Our fastest time was 70 trays or 280 dots in 3 minutes 35 seconds! That is 280 dots in 225 seconds! The machine works great! We are way faster and less fatigued at the end of a job, using the Shot Pot with Timer. Thanks Pierce and thanks Glue Machinery Corporation. CD Tray Assembly Company ( Please call for reference)


OPTIONAL
Auto Trigger (Single or Dual) Sensor Package
Click for Details