Product Details:

• Complete "Turn-Key" bench top hot melt extrusion system
• Melt On Demand melt tank configuration
• Foot switch with cable to unit to actuate adhesive flow
• 3.5 lb. hot melt tank capacity, Teflon lined
•  5 lb. per hour melt rate depending on adhesive
• Removable melt grid in bottom of tank
• Thermostatically adjustable temperature controller in centigrade, 50 to 200 C
• Pneumatically adjustable adhesive flow control
• High Speed valve/module for excellent adhesive shut off
• Adjustable timer from .25 to 9 seconds for pre-measured adhesive patterns
• Typical Adhesive viscosities range between 500 and 5000 cps
• Typical hot melts used with system are Fugitive Removeable/Peelable, Permanent EVA's, APAO's, Polyamides and  pressure sensitives 
• Power requirements are 240 VAC
• Dimensions are 18" high x 15" wide x 13.5" deep
• Weight is 32.5 lbs.
• Compressed air required: 30-90psi
• Six month warranty against defective workmanship
• Method of shipment is UPS